LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the engine mount bracket to the engine.
  2. Connect the knock sensor harness connector and install the shield. Refer to Knock Sensor (KS) 2 Replacement in engine Controls - 3.8L (L26 and L32).
  3. Install the rear engine mount bracket bolts to the engine. Hand tighten the bolts at this time.
  4. Install the front engine mount bracket bolts to the engine. Hand tighten the bolts at this time.
    5. Fig 1: Front Engine Mount Bracket Bolts
    GM97800Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Tighten the engine mount bracket bolts.

    Tighten:  Tighten the bolts to 102 N.m (75 lb ft).

    6. Fig 2: Rear Engine Mount Bracket Bolts
    GM97804Courtesy of GENERAL MOTORS CORP.
  6. Install the engine mount. Refer to Engine Mount Replacement .
  7. Install the A/C compressor to the engine. Refer to Compressor Replacement (L26 L32) in Heating, Ventilation and Air Conditioning.
  8. Install the drive belt. Refer to Drive Belt Replacement (L26)  or Drive Belt Replacement (L32) .
  9. Install the transmission. Refer to Transmission Replacement in Automatic Transaxle - 4T65-E.
scientia non olet · About LEMON Manuals