LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Tensioner Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Drain the cooling system. Refer to Draining and Filling Cooling System in Engine Cooling.
  3. Remove the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement (L26 L32) in Engine Cooling.
  4. Remove the drive belt. Refer to Drive Belt Replacement (L26)  or Drive Belt Replacement (L32) .
  5. Remove the generator. Refer to Generator Replacement in Engine Electrical.
  6. Remove the heater hose adapters with the heater hoses from the drive belt tensioner. Refer to Heater Hose Replacement - Inlet (L26, L32) and to Heater Hose Replacement - Outlet (L26, L32) in Heating, Ventilation and Air Conditioning.
  7. Remove the drive belt tensioner bolts.
    8. Fig 1: View Of Drive Belt Tensioner
    GM326960Courtesy of GENERAL MOTORS CORP.
  8. Remove the drive belt tensioner.
  9. If replacing the drive belt tensioner, remove the thermostat bypass upper and lower pipe assemblies.
scientia non olet · About LEMON Manuals