LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Idler Pulley Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drive belt idler pulley bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the idler pulley bracket bolts.

    Tighten:  Tighten the bolts to 30 N.m (22 lb ft).

    3. Fig 1: Driver Belt Idler Pulley Bracket & Bolts
    GM327162Courtesy of GENERAL MOTORS CORP.
  3. Install the drive belt idler pulley.
  4. Install the drive belt idler pulley bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

    5. Fig 2: Identifying Drive Belt Idler Pulley - Lower
    GM327164Courtesy of GENERAL MOTORS CORP.
  5. Install the supercharger drive belt. Refer to Drive Belt Replacement (L26)  or Drive Belt Replacement (L32) .
    6. Fig 3: View Of Supercharger Drive Belt
    GM327021Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals