Crankshaft Balancer Removal

Tools Required

• J 37096  Flywheel Holder
• J 38197-A  Crankshaft Balancer Remover

1. Use J 37096  in order to hold the flywheel.
Fig 1: Holding Flywheel
Courtesy of GENERAL MOTORS CORP.
2. Remove the crankshaft balancer bolt.
Fig 2: Crankshaft Balancer Bolt
Courtesy of GENERAL MOTORS CORP.
3. Use the J 38197-A  in order to remove the crankshaft balancer.
   IMPORTANT: Do not separate the crankshaft pulley from the crankshaft balancer. Service the crankshaft pulley and the crankshaft balancer as an assembly.
   1. Invert J 38197-2 so the leg of the tool is facing away from the crankshaft balancer.
   2. Install the silver screws J 38197-4 to the crankshaft balancer.
   3. Turn J 38197-1 to remove the crankshaft balancer from the crankshaft.
   4. Remove J 38197-1, J 38197-2, and J 38197-4 from the crankshaft balancer.
Fig 3: Using J 38197-A To Remove Crankshaft Balancer
Courtesy of GENERAL MOTORS CORP.