LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (Exterior Trim) >> Repair Instructions >> Emblem/Nameplate Replacement - Rear Compartment Lid >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Apply the emblem/nameplate in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion.
  1. Ensure the area where the emblem/nameplate will be installed is clean and dry.
  2. Apply tape and mark the location as shown for the emblem/nameplate.
  3. Heat the mounting surface to approximately 27-41°C (80-105°F) using the J 25070  , if necessary.
  4. Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).
    5. IMPORTANT: Do not touch the adhesive backing of the emblem/nameplate.
  5. Remove the protective liner from the back of the emblem/nameplate.
  6. Position the emblem/nameplate (1,2) to the location marks and press the emblem/nameplate to the mounting surface.
  7. Apply equal pressure along the emblem/nameplate (1,2) to uniformly bond the item to the mounting surface.
    8. Fig 1: Locating Rear Compartment Lid Emblem/Nameplate
    GM1258096Courtesy of GENERAL MOTORS CORP.
  8. Remove the protective tape from the mounting surface.
scientia non olet · About LEMON Manuals