Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Raise the rear compartment lid.
- Apply tape to the fascia and adjacent surfaces.
- Remove the rear compartment sill plate. Refer to Compartment Sill Plate Replacement - Rear in Body Rear End.
- Pull the left and right compartment side trim panels down to access the fascia bolts (1) and nuts (2).
- Remove the tail lamps. Refer to Tail Lamp Assembly and/or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement in Lighting Systems.
- Remove the fascia bolts (1) and nuts (2) from the rear bumper fascia.
- Remove the push-in retainers (3) from the top edge of the fascia.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the push-in retainers (5) from the rear bumper fascia using the J 38778 .
- Remove the fascia bolts (6) from the rear bumper fascia.
- Remove the rear bumper fascia (4) from the vehicle.
- Remove the screws from the rear bumper energy absorber.
- Remove the rear bumper energy absorber from the rear fascia.
NOTE:
Refer to Tape Corners of Panel Notice
in Cautions and Notices.