LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Body Front End) >> Repair Instructions >> Hood Hinge Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
  1. Remove the hood. Refer to Hood Replacement .
  2. Remove the rear hood side seal. Refer to Seal Replacement - Hood Rear Side .
  3. Remove the hood assist rod. Refer to Assist Rod Replacement - Hood .
  4. Loosen the hood hinge to fender bolts, but do not remove the bolts.
    5. Fig 1: View Of Hood Hinge & Fender Bolts
    GM363782Courtesy of GENERAL MOTORS CORP.
  5. Center punch the spot weld
    6. Fig 2: Center Punching Spot Weld
    GM363781Courtesy of GENERAL MOTORS CORP.
  6. Drill out the spot weld using a 9.5 mm (3/8 in) drill bit.
    7. Fig 3: Drilling Out Spot Weld
    GM363778Courtesy of GENERAL MOTORS CORP.
  7. Remove the hood hinge to fender bolts.
  8. Remove the hood hinge from the fender.
  9. Repair the paint on the fender where the hood hinge was removed. Refer to Anti-Corrosion Treatment and Repair in Paint/Coatings.
scientia non olet · About LEMON Manuals