LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Rear Seat Belt Retractor
    GM157291Courtesy of GENERAL MOTORS CORP.
  1. Position the rear seat retractor in the vehicle.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Position the retractor alignment tabs.
  3. Install the rear seat retractor bolt.

    Tighten:  Tighten the bolt to 68 N.m (50 lb ft).

  4. Fig 2: Retractor Side Belt Anchor Bolt
    GM1277001Courtesy of GENERAL MOTORS CORP.
  5. If you are installing a side retractor, install the retractor side belt anchor bolt to the floorpan.

    Tighten:  Tighten the bolt to 42 N.m (31 lb ft).

  6. Install the rear window trim panel. Refer to Trim Panel Replacement - Rear Window Shelf in Interior Trim.
  7. Install the rear seat back. Refer to Seat Back Replacement - Rear (Folding) in Seats.
  8. Install the seat cushion. Refer to Seat Cushion Replacement - Rear in Seats.