Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the reservoir (1) for cracks or deformation. If found, replace the reservoir.
- Clean the reservoir with denatured alcohol, or equivalent.
- Dry the reservoir with non-lubricated, filtered air.
- Lubricate the new seals (2) and the outer surface area of the reservoir-to-housing barrels with Delco Supreme 11®, GM P/N 12377967 (Canadian P/N 992667) or equivalent DOT-3 brake fluid from a clean, sealed brake fluid container.
- Install the lubricated seals (2), make sure they are fully seated.
- Install the reservoir (1) to the master cylinder, by pressing the reservoir straight down on the master cylinder until the pin holes are aligned.
- Carefully tap the reservoir retaining pins into place to secure the reservoir.
- Place the brake fluid level sensor into the reservoir, press into place to secure the sensor retaining tabs.
- Remove the master cylinder from the vise.
- Install master cylinder to the vehicle. Refer to Master Cylinder Replacement .