LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Hydraulic Brake System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left instrument panel insulator.
  2. Push the BCM up and move the bottom of the BCM away from and out of the mounting bracket slot. Position the BCM aside.
  3. Remove the stoplamp switch. Refer to Brake Pedal Position Sensor Replacement in Lighting Systems.
  4. Remove the cruise control release switch, if equipped.
  5. Release the wiring harness clips from the bracket.
  6. Remove the brake pedal pushrod retaining clip from the brake pedal.
  7. Remove the brake pedal pushrod and washer from the brake pedal.
    8. Fig 1: Break Pedal Pushrod Retaining Clip, Pushrod & Washer
    GM179276Courtesy of GENERAL MOTORS CORP.
  8. Remove the brake pedal nut and bolt.
    9. Fig 2: Break Pedal Nut & Bolt
    GM630032Courtesy of GENERAL MOTORS CORP.
  9. Remove the brake pedal and bushings.
scientia non olet · About LEMON Manuals