Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- If necessary, remove the cover (1) from the retainer (2).
- Route the connector through the retainer. Align the retainer to the slot in the opening.
- Install the retainer by pressing into place until fully seated.
- Connect the electrical connector to the receptacle.
- Align the tabs on the receptacle to the slots in the retainer. Install the receptacle by pressing into place until fully seated.
- If a lighter was installed, install the element.
If a power auxiliary outlet was installed, close the cover.
- Install the auxiliary power outlet fuse to the underhood fuse block.
IMPORTANT:
If you are installing a lighter, remove the cover from the retainer.