Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the accessory power receptacle fuse.
- Raise the floor console armrest.
- Cover the handle end of the J 42059 with tape to avoid scratching the floor console compartment. See Special Tools and Equipment .
- Remove the accessory power receptacle by placing one side of the "T" portion of the J 42059 into the receptacle opening. See Special Tools and Equipment . Angle the other side into the opposite opening. Pull the accessory power receptacle straight out.
- If the standard method fails to remove the socket, use the following alternate method:
- Insert a small grinding tool with a cutoff wheel into the socket.
- Remove the plastic latches in the 3-mm (0.11-in) square windows.
- Use J 42059 as directed above to remove the socket. See Special Tools and Equipment .
- Remove J 42059 . See Special Tools and Equipment .
- Disconnect the electrical connector. Make sure the connector remains routed through the opening.
- Remove the receptacle.
- Remove the accessory power receptacle retainer.