Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the protective backing from the adhesive strips on the ends of the spoiler (1).
- Position the rear spoiler to the rear compartment lid.
- Route the electrical connector for the high mount stop lamp through the rear compartment lid.
- Ensure that the high mount stop lamp grommet is fully seated.
- Install the nuts (3) to the studs on the rear compartment lid spoiler.
Tighten: Tighten the nuts to 6 N.m (53 lb in).
- Connect the high mount stop lamp electrical connector.
- Close the rear compartment.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.