Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Turn Signal Switch Housing & Steering Column Shaft Assembly

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The switch mounting bracket must be pressed firmly against the steering column tilt head.

Slide the turn signal switch housing onto the steering column shaft assembly.
Install the turn signal switch assembly. Refer to Multifunction, Turn Signal Switch Replacement .
Install the wiper washer switch assembly. Refer to Wipers/Washer Switch Replacement in Wipers/Washer Systems.
Install the turn signal cancel cam assembly. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.