LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Steering Wheel And Steering Column) >> Repair Instructions >> Seal Replacement - Intermediate Steering Shaft >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the intermediate shaft seal over the intermediate shaft from inside the vehicle.
  2. Connect the intermediate shaft to the steering column as noted during removal.
    3. Fig 1: View Of Upper Pinch Bolt Of Intermediate Steering Shaft
    GM454259Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the upper intermediate shaft pinch bolt.

    Tighten:  Tighten the bolt to 48 N.m (35 lb ft).

    4. Fig 2: Intermediate Shaft Seal
    GM1206798Courtesy of GENERAL MOTORS CORP.
  4. Install the intermediate shaft seal bolts.

    Tighten:  Tighten the intermediate shaft seal bolts to 3 N.m (27 lb in).

  5. Connect the intermediate shaft seal to the steering column.
    6. Fig 3: Lower Intermediate Shaft Seal To Steering Gear
    GM1206804Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Rotate the lower seal in order to obtain proper shaft to seal clearance.
  6. Connect the lower intermediate shaft seal to the steering gear.
scientia non olet · About LEMON Manuals