LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Steering Wheel And Steering Column) >> Repair Instructions >> Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the intermediate steering shaft into the seal.
    2. Fig 1: View Of Upper Pinch Bolt Of Intermediate Steering Shaft
    GM454259Courtesy of GENERAL MOTORS CORP.
  2. Connect the intermediate shaft to the steering column as noted during removal.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the upper intermediate steering shaft pinch bolt.

    Tighten:  Tighten the pinch bolt to 48 N.m (35 lb ft).

  4. Connect the intermediate steering shaft seal onto the steering column.
  5. Raise the vehicle.
    6. Fig 2: Intermediate Steering Shaft & Power Steering Gear Stub
    GM1206804Courtesy of GENERAL MOTORS CORP.
  6. Connect the intermediate steering shaft to the power steering gear stub shaft as noted during removal.
  7. Install the lower intermediate steering shaft pinch bolt.

    Tighten:  Tighten the pinch bolt to 48 N.m (35 lb ft).

  8. Connect the intermediate steering shaft seal onto the power steering gear. Rotate the lower seal as necessary to gain maximum clearance.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals