LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Engine Controls (Introduction) - 3.8L) >> Repair Instructions >> Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L26) or Fuel Injector Sight Shield Replacement (L32) in Engine Mechanical - 3.8L.
    2. IMPORTANT: The intake air temperature (IAT) sensor and the mass air flow (MAF) sensor are combined as one sensor.
  2. Disconnect the MAF/IAT sensor electrical connector (2).
  3. Loosen the air cleaner intake duct clamps.
  4. Remove the air cleaner intake duct from the air cleaner housing cover and the throttle body assembly.
    5. Fig 1: Identifying MAF/IAT Sensor
    GM1208107Courtesy of GENERAL MOTORS CORP.
  5. Remove the MAF/IAT sensor from the air cleaner intake duct.
scientia non olet · About LEMON Manuals