LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Engine Controls (Introduction) - 3.8L) >> Repair Instructions >> Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the MAF/IAT sensor to the air cleaner intake duct.
  2. Install the air cleaner intake duct to the air cleaner housing cover and the throttle body assembly.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the air cleaner intake duct clamp screws.

    Tighten:  Tighten the duct clamps to 3 N.m (27 lb in).

  4. Connect the MAF/IAT sensor electrical connector.
  5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L26) or Fuel Injector Sight Shield Replacement (L32) in Engine Mechanical - 3.8L.
scientia non olet · About LEMON Manuals