LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Engine Controls (Introduction) - 3.8L) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement (L26) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L26) or Fuel Injector Sight Shield Replacement (L32) in Engine Mechanical - 3.8L.
  2. Disconnect the MAP sensor electrical connector.
  3. Carefully release the locking tabs holding the MAP (1) sensor to the PCV valve cover (2) just enough to remove the MAP sensor.
  4. Fig 1: View Of MAP Sensor (L26)
    GM12346Courtesy of GENERAL MOTORS CORP.
  5. Pull the MAP sensor straight out of PCV valve cover.