LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Engine Controls (Introduction) - 3.8L) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement (L26) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure that the seal is installed on the MAP sensor and that the seal is not damaged.
  2. Position and install the MAP sensor (1) to the PCV valve cover (2). Ensure that the locking tabs engage to hold the MAP sensor to the PCV valve cover.
    3. Fig 1: View Of MAP Sensor (L26)
    GM12346Courtesy of GENERAL MOTORS CORP.
  3. Connect the MAP sensor electrical connector.
  4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L26) or Fuel Injector Sight Shield Replacement (L32) in Engine Mechanical - 3.8L.
scientia non olet · About LEMON Manuals