LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Engine Controls (Introduction) - 3.8L) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the EVAP purge valve (3).
    2. Fig 1: View Of EVAP Purge Valve
    GM911046Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the EVAP purge valve bolt (2).

    Tighten:  Tighten the bolt to 12 N.m (106 lb in)

  3. Connect the EVAP canister purge valve electrical connector.
  4. Connect the EVAP canister purge valve purge pipe (2). Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    5. Fig 2: Female Connector & Fuel Rail Pipe
    GM910914Courtesy of GENERAL MOTORS CORP.
  5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L26) or Fuel Injector Sight Shield Replacement (L32) in Engine Mechanical - 3.8L.
scientia non olet · About LEMON Manuals