LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Engine Controls (Introduction) - 3.8L) >> Repair Instructions >> Barometric Pressure (BARO) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L26) or Fuel Injector Sight Shield Replacement (L32) in Engine Mechanical - 3.8L.
  2. Disconnect the BARO sensor electrical connector.
    3. Fig 1: Locating MAP & BARO Sensors
    GM1210599Courtesy of GENERAL MOTORS CORP.
  3. Remove the BARO sensor retainer.
  4. Remove the BARO sensor.
scientia non olet · About LEMON Manuals