LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Cruise Control System) >> Diagnostic Information and Procedures >> DTC P1574 >> Diagnostic Aids

Diagnostic Aids

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

In order to avoid a misdiagnosis, inspect for proper operation of the stop lamps. Refer to Exterior Lighting Systems Description and Operation in Lighting Systems.

For an intermittent condition, refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.

DTC P1574

Step Action Yes No
Schematic Reference : Cruise Control Schematics 
Connector End View Reference: Powertrain Control Module (PCM) Connector End Views in Engine Controls - 3.8 L (L26 and L32)
1 Did you perform the Cruise Control Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Cruise Control 
2 Is DTC P0573 current in the PCM? Go to DTC P0573 in Lighting Systems Go to Step 3 
3 Do the stop lamps operate properly? Go to Step 4  Go to Stop Lamps Inoperative in Lighting Systems
4
  1. Install a scan tool.
  2. Turn the ignition ON, with the engine OFF.
  3. With the scan tool, observe the Stoplamp Status parameter in the PCM Cruise Control Data list.
Does the Stoplamp Status parameter display On?
Go to Step 5  Go to Diagnostic Aids
5 Test the stop lamp switch signal circuit for an open or for a high resistance. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 8  Go to Step 6 
6 Inspect for poor connections at the harness connector of the TAC module. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 8  Go to Step 7 
7 Replace the TAC module. Refer to Throttle Body Assembly Replacement (L26)Throttle Body Assembly Replacement (L32) in Engine Controls - 3.8L (L26 and L32).
Did you complete the replacement?
Go to Step 8  -
8
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the conditions for running the DTC.
Does the DTC reset?
Go to Step 2  System OK