LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Seat System) >> Repair Instructions >> Seat Back Cover Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rear seat back cover on the pad.
  2. Pull the rear seat back cover down over the pad. Align the hook and the loop retainers.
    3. Fig 1: Rear Seat Back Cover
    GM520586Courtesy of GENERAL MOTORS CORP.
  3. Use firm hand pressure to fasten the hook and loop retainers, securing the cover to the pad.
  4. Install the staples to the seat back, lower trim flaps.
  5. Pull the rear seat back cover over the pad and pull over and under the bottom.
    6. Fig 2: Installing Rear Seat Back Cover
    GM520580Courtesy of GENERAL MOTORS CORP.
  6. Connect the J-hook on the bottom of the seat back.
  7. Position the cargo net retainers on the seat back.
    8. NOTE: Refer to Fastener Notice in Cautions and Notices.
  8. Install the cargo net retainer bolts.

    Tighten:  Tighten the bolt to 3 N.m (27 lb in).

    9. Fig 3: Bolts From Cargo Net Retainers
    GM1219249Courtesy of GENERAL MOTORS CORP.
  9. Engage the inboard side of the seat section on the pivot arm which is located on the lower frame (2).
    10. Fig 4: Engaging Inboard Side Of Rear Seat Section On Pivot Arm & Lower Frame
    GM799804Courtesy of GENERAL MOTORS CORP.
  10. Rotate the seat back section to the installed position.
  11. Install the pivot bolt.

    Tighten:  Tighten the bolt to 24 N.m (18 lb ft).

    12. Fig 5: Pivot Bolt & Fold Down Section
    GM864893Courtesy of GENERAL MOTORS CORP.
  12. Install the rear seat cushion. Refer to Seat Cushion Replacement - Rear .
scientia non olet · About LEMON Manuals