LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Seat System) >> Repair Instructions >> Seat Back Bolster Replacement - Rear Split Folding >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat back. Refer to Seat Back Replacement - Rear (Folding) .
  2. Remove the push-in J-hook retainers from both rear seat bolsters.
    3. Fig 1: J-Hook Retainers & Rear Seat Bolsters
    GM530923Courtesy of GENERAL MOTORS CORP.
  3. Pull back the trim on the right bolster in order to expose the rear compartment release handle cable, if equipped.
    4. Fig 2: Installing Bolster Trim Covers (Rear Split Folding)
    GM530918Courtesy of GENERAL MOTORS CORP.
  4. Reposition the compartment release handle cable from the right seat bolster, if equipped.
  5. Pull back the seat bolster trim to expose the seat frame bolts.
  6. Remove the bolts from the left and/or the right seat bolster.
    7. Fig 3: Bolts From Left & Right Seat Bolster
    GM530859Courtesy of GENERAL MOTORS CORP.
  7. Remove the left and/or the right seat bolster from the seat back frame.
  8. Remove the J-hook retainers (1) from the pad support frame (2).
    9. Fig 4: J-Hook Retainers & Pad Support Frame
    GM1219255Courtesy of GENERAL MOTORS CORP.
  9. Remove the bolster trim covers from the bolsters pads.
scientia non olet · About LEMON Manuals