Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Install the rear seat bolster trim cover over the rear seat bolster pad.

Fig 1: Installing Bolster Trim Covers (Rear Split Folding)

Courtesy of GENERAL MOTORS CORP.

Install the J-hook retainers (1) to the support frame (2).

Fig 2: J-Hook Retainers & Pad Support Frame

Courtesy of GENERAL MOTORS CORP.

Reposition the trim cover side flap on the bolster under and over the side rail of the seat back frame.

Fig 3: Installing Bolster Trim Covers (Rear Split Folding)

Courtesy of GENERAL MOTORS CORP.

Reposition the release handle cable to the right seat bolster, if equipped.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolts to the left and/or the right seat bolsters.
Tighten: Tighten the bolts to 6 N.m (53 lb in).

Fig 4: Bolts From Left & Right Seat Bolster

Courtesy of GENERAL MOTORS CORP.

Install the rear seat back. Refer to Seat Back Replacement - Rear (Folding) .