Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Place the adjuster covers on the seat adjuster.
Place the seat back frame on the adjuster covers.

Fig 1: Adjuster Cover Plates

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolts that secure the seat back to the adjuster.
Tighten: Tighten the bolts to 24 N.m (18 lb ft).

Fig 2: Front Seat Back Frame Bolts

Courtesy of GENERAL MOTORS CORP.

Install the seat pan.
Install the bolts that secure the seat pan to the adjuster.
Tighten: Tighten the bolts to 24 N.m (18 lb ft).

Fig 3: Front Seat Pan Bolts

Courtesy of GENERAL MOTORS CORP.

Install the seat pad and trim cover together.

Fig 4: Rear Cushion Cover (Front Seat)

Courtesy of GENERAL MOTORS CORP.

Install the seat cushion J-hooks and the hook and loop retainers to secure the trim to the seat pan.
Press down on the cushion trim pad to secure the hook and loop retainers to the seat pad.
Install the electrical harness clip and the retainer on the adjuster bracket.

Fig 5: Electrical Harness Clip & Harness Retainer

Courtesy of GENERAL MOTORS CORP.

Connect the electrical harness to the seat motor harness.

Fig 6: Electrical Harness & Power Seat Motor Harness

Courtesy of GENERAL MOTORS CORP.

Install the seat belt pretensioner. Refer to Seat Belt Buckle Pretensioner Replacement in SIR.
Install the seat belt bracket.
Install the seat trim panel. Refer to Trim Panel Replacement - Front Seat .

IMPORTANT: Inspect the drive cables. Verify that the cables are straight between the motors and the drive screws.

Install the front seat. Refer to Seat Replacement - Front Bucket .