Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Position the relay to the front seat.

Fig 1: Heater Relay, Push-In Retainer & Electrical Harness Connector (Front Seat)

Courtesy of GENERAL MOTORS CORP.

Connect the electrical harness connector (3) to the relay (2).
Position the relay (2) on the frame and push in to attach the retainer (1)
Lower the seat.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolts that secure the front bucket seat adjuster to the floor pan.
Tighten: Tighten the bolts to 42 N.m (31 lb ft).
Reposition the front seat to the original position.