LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Trim Plate Replacement - Instrument Panel (I/P) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the I/P outboard trim plate retainers to the slots in the I/P trim pad. Press the trim plate to the I/P trim pad.
    2. Fig 1: View Of I/P Trim Plate
    GM929399Courtesy of GENERAL MOTORS CORP.
  2. Install the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory .
    3. Fig 2: I/P Accessory Trim Plate
    GM928809Courtesy of GENERAL MOTORS CORP.
  3. If the I/P compartment is equipped with a dampener engage the door stop using the following procedure:
    1. Press the upper door stop (2) toward the center of the vehicle.
    2. Rotate the door up to the compartment.
    4. Fig 3: View Of Upper Door Stop
    GM1332713Courtesy of GENERAL MOTORS CORP.
  4. If the I/P compartment is not equipped with a dampener, install the door stop as shown.
    5. Fig 4: I/P Compartment Door Stop
    GM929422Courtesy of GENERAL MOTORS CORP.
  5. Close the I/P compartment.
scientia non olet · About LEMON Manuals