LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Trim Plate Replacement - Instrument Panel (I/P) Accessory >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Use a plastic trim tool to remove the ignition switch bezel.
    2. Fig 1: Identifying Ignition Cylinder Bezel
    GM910510Courtesy of GENERAL MOTORS CORP.
  2. Pull the instrument panel (I/P) accessory trim plate rearward.
    3. Fig 2: I/P Accessory Trim Plate
    GM928809Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the electrical connector from the driver information display assembly.
    4. Fig 3: Electrical Connector & Driver Information Display
    GM928828Courtesy of GENERAL MOTORS CORP.
  4. Remove the driver information display screws.
  5. Remove the driver information display.
  6. Remove the I/P center air outlet screws.
  7. Remove the I/P center air outlet.
    8. Fig 4: I/P Center Air Outlet & Screws
    GM928622Courtesy of GENERAL MOTORS CORP.
  8. Remove the I/P accessory trim plate.
scientia non olet · About LEMON Manuals