Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Position the I/P center air outlet to the I/P accessory trim plate.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the I/P center air outlet screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 1: I/P Center Air Outlet & Screws

Courtesy of GENERAL MOTORS CORP.

Place the driver information display on the I/P accessory trim plate
Install the driver information display screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Connect the electrical connector to the driver information display.

Fig 2: Electrical Connector & Driver Information Display

Courtesy of GENERAL MOTORS CORP.

Press the I/P accessory trim plate to the I/P.

Fig 3: View Of I/P Accessory Trim Plate

Courtesy of GENERAL MOTORS CORP.

Install the ignition switch bezel.

Fig 4: Identifying Ignition Cylinder Bezel

Courtesy of GENERAL MOTORS CORP.