Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Align the compartment to the upper trim plate.

Fig 1: View Of Compartment & Upper Trim Plate (Front Floor)

GM902852

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the compartment screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 2: View Of Compartment & Screws (Front Floor)

GM902840

Courtesy of GENERAL MOTORS CORP.

Align the side trim panels to the locators.

Fig 3: View Of Side Trim Panel Screws (Front Floor)

GM902830

Courtesy of GENERAL MOTORS CORP.

Install the side trim panel screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the compartment screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 4: View Of Compartment Screws (Front Floor)

GM902750

Courtesy of GENERAL MOTORS CORP.

Align the rear cover to the floor console.

Fig 5: View Of Rear Cover (Front Floor)

GM902776

Courtesy of GENERAL MOTORS CORP.

Install the rear cover screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 6: View Of Rear Cover Screws

GM902793

Courtesy of GENERAL MOTORS CORP.

Install the armrest and the hinge. Refer to Console Armrest Replacement - Front Floor .
Install the accessory power receptacles. Refer to Cigar Lighter Housing Replacement - Floor Console and to Accessory Power Receptacle Replacement - Floor Console in Power Outlets.
Install the traction control switch. Refer to Traction Control Switch Replacement in Anti-lock Brake System.
Install the HUD switch, if equipped. Refer to Head Up Display Switch Replacement .
Install the wiring harness.
Install the cupholder liner.
Install the ashtray insert.
Install the floor console. Refer to Console Replacement - Front Floor .