LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Knee Bolster Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the harness retainer to the knee bolster. Verify that the harness is not pinched between the bolster bracket and the I/P carrier cross car beam.
    2. Fig 1: Harness Retainer & Driver Side Knee Bolster
    GM928918Courtesy of GENERAL MOTORS CORP.
  2. Align the knee bolster to the I/P.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Start the bolts by hand to avoid cross threading. Install the knee bolster bolts to the I/P carrier cross car beam.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    4. Fig 2: Left Knee Bolster Bolts
    GM929383Courtesy of GENERAL MOTORS CORP.
  4. Install the knee bolster screws at the I/P lower trim panel.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    5. Fig 3: Left Knee Bolster Screws
    GM928866Courtesy of GENERAL MOTORS CORP.
  5. Install the steering column filler. Refer to Steering Column Filler Replacement .
  6. Install the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory .
  7. Install the ignition switch bezel.
    8. Fig 4: Identifying Ignition Cylinder Bezel
    GM910510Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals