Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Paint Damage Notice in Cautions and Notices.

Apply masking tape to the door frame and applique.
Lower the window to the full down position.
Remove the window channel retainer. Refer to Window Channel Retainer Replacement - Rear Door .
Remove the screws (1, 2) from the upper and lower corners of the inside door frame.

Fig 1: Inside Door Frame Screws & Weatherstrip (Rear Door)

Courtesy of GENERAL MOTORS CORP.

Pull the window run channel weatherstrip out of the retainer and reposition it in order to access to the applique rivets.
Drill out the 4 mm (5/32 in) rivets along the inside edge of the window channel retainer.

Fig 2: Window Channel Retainer Rivets & Door Frame Applique/Run Channel (Rear Door)

Courtesy of GENERAL MOTORS CORP.

Pull upward to release the applique from the door frame.