LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Door System, Mirror System & Window System) >> Repair Instructions >> Door Frame Applique/Run Channel Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Paint Damage Notice in Cautions and Notices.
  1. Apply masking tape to the door frame and applique.
  2. Remove the front door trim panel. Refer to Trim Panel Replacement - Side Front Door .
  3. Remove the window channel retainer. Refer to Window Channel Retainer Replacement - Front Door .
  4. Remove the screws (1,2) from the upper and lower corners of the door frame.
  5. Fig 1: Inside Door Frame Screws & Weatherstrip (Front Door)
    GM794036Courtesy of GENERAL MOTORS CORP.
  6. Pull the door window run channel weatherstrip down and reposition it in order to access to the applique rivets.
  7. Drill out the 4 mm (5/32 in) rivets along the inside edge of the door window channel retainer.

    Pull upward to release the applique from the door frame.

  8. Fig 2: Window Channel Retainer Rivets & Door Frame Applique/Run Channel (Front Door)
    GM800468Courtesy of GENERAL MOTORS CORP.