LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Lighting Systems) >> Repair Instructions >> Headlamp Aiming >> Headlamp Aiming Procedure

Headlamp Aiming Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
    2. Fig 1: Measuring Distance Between Headlamps Face & Aiming Screen
    GM418400Courtesy of GENERAL MOTORS CORP.
  2. Measure from the floor to the center of the headlamp bulb. Some headlamps have an aim dot marked on the headlamp lens.
  3. At the screen, measure from the floor and place the horizontal tape at the measured distance.
  4. Measure from the reference line on the floor to the left headlamp bulb centerline.
  5. At the screen, measure from the reference line and place the vertical tape at the measured distance.
  6. Measure from the reference line on the floor to the right headlamp bulb centerline.
  7. At the screen, measure from the reference line and place the vertical tape at the measured distance.
    8. IMPORTANT: DO NOT cover the headlamp, this may cause excessive heat build up.
    Fig 2: Right Side Low Beam Proper Screen Positioning
    GM476831Courtesy of GENERAL MOTORS CORP.
  8. Turn on the low beam headlamps and block the light from projecting onto the screen from the passenger side headlamp.
  9. Horizontal aim is not adjustable on this vehicle.

    Adjust the vertical aim screw (2) of the headlamps to the specifications required by the state and the local authorities, or as shown in step number 8.

    10. Fig 3: View Of Headlamp Retainer
    GM1228437Courtesy of GENERAL MOTORS CORP.
  10. Repeat the aiming procedure for the passenger side headlamp while blocking the light from projecting onto the screen from the driver side headlamp.
  11. Turn the headlamps OFF.
  12. Close the hood.
scientia non olet · About LEMON Manuals