LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Lighting Systems) >> Repair Instructions >> Daytime Running Lamps (DRL) Ambient Light Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: DRL Ambient Light Sensor & Connector
    GM929317Courtesy of GENERAL MOTORS CORP.
  1. Install the DRL ambient light sensor to the DRL ambient light sensor connector.
  2. Position the DRL ambient light sensor to the opening in the I/P upper trim panel. Rotate the DRL ambient light sensor clockwise.
  3. Verify that the DRL ambient light sensor wiring harness will not be pinched when the I/P upper trim panel is installed. Press down on the I/P upper trim panel in order to engage the retainers to the I/P trim pad.
  4. Install the garnish moldings to the left and right windshield pillars. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
scientia non olet · About LEMON Manuals