Installation Procedure

Align the compartment housing to the I/P.
Press inward on both sides of the I/P compartment housing and rotate upward and into the I/P.
Hand tighten the screws to the I/P compartment hinge.
Align the I/P compartment housing to the I/P for the proper fit.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the screws to the I/P compartment hinge.
Tighten

Tighten the screws to 2 N.m (18 lb in).

Fig 1: View Of I/P Compartment Housing
Courtesy of GENERAL MOTORS CORP.
Open the I/P compartment.
Connect the loop of the damper cord (1) to the I/P support.

Fig 2: Connecting Loop Of Damper Cord To I/P Support
Courtesy of GENERAL MOTORS CORP.
Close the I/P compartment.
Install the right I/P insulator. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - RIGHT .