LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2003 >> Century Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Brake Pedal Assembly >> Removal

Brake Pedal Assembly: Removal

  1. Remove the left instrument panel insulator.
  2. Remove the Body Control Module (BCM) from the bracket and position aside.
  3. Remove the stoplight switch. See STOPLIGHT SWITCH  .
  4. Remove the cruise control release switch, if equipped.
  5. Remove the wiring harness clips from the bracket.
  6. Remove the brake pedal pushrod retaining clip from the brake pedal. See Fig 1 .
  7. Remove the brake pedal pushrod and washer from the brake pedal.
  8. Remove the brake pedal nut and bolt. See Fig 2 . Remove the brake pedal and bushings.
Fig 1: Removing & Installing Brake Pedal Pushrod Retaining Clip
G00284629Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Brake Pedal Nut and Bolt
G00284630Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals