Removal Procedure

Important:  The ignition switch must be in the OFF position when removing the instrument panel cluster (IPC).

1. Remove the cluster trim plate. Refer to Trim Plate Bezel Replacement - I/P Cluster .
2. Remove the screws from the IPC.
Fig 1: Identifying Instrument Panel Cluster (IPC)
Courtesy of GENERAL MOTORS CORP.
3. In order to remove the IPC, perform the following procedures:
   1. 3.1. Rotate the top of the cluster rearward.
   2. 3.2. Disengage the locating pins on the bottom of the cluster.
4. Disconnect the electrical connector from the cluster.
   Fig 2: Identifying Instrument Panel Cluster (IPC) Electrical Connector

   Courtesy of GENERAL MOTORS CORP.