Audible Warnings System Diagnostic System Check
NOTE:
Use this check as the starting point for any audible warnings system complaint.
- Turn ignition switch to OFF position. Connect scan tool to Data Link Connector (DLC). DLC is located below left side of instrument panel, to right of steering column. See Figure . Turn ignition switch to RUN position. If scan tool powers up, go to next step. If scan tool does not power up, see TEST G: SCAN TOOL DOES NOT POWER UP in appropriate BODY CONTROL MODULES article.
- Try to establish scan tool communication with all modules. If communication with all modules is established, go to next step. If communication with all modules is not established, go to TEST F: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE in appropriate BODY CONTROL MODULES article.
- Select DISPLAY DTC function for each module. Record all displayed DTCs and status of displayed DTCs. If any DTCs are displayed, go to next step. If no DTCs are displayed, attempt to diagnose system by symptom. See SYMPTOM INDEX table under SYSTEM TESTS.
- If scan tool does not display any DTCs that begin with "U", go to next step. If scan tool displays any DTCs that begin with "U", go to TEST F: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE in appropriate BODY CONTROL MODULES article.
- If scan tool does not display DTC B1000, B1004, B1007, B1009, B1013, , B1334, B1339, B1354 or B1422, go to next step. If scan tool displays DTC B1000, B1004, B1007, B1009, B1013, , B1334, B1339, B1354 or B1422, perform appropriate test. See appropriate BODY CONTROL MODULES article.
- If scan tool displays DTCs P0560 or P0620, see appropriate GENERATORS & REGULATORS article STARTING & CHARGING SYSTEMS. If scan tool does not display DTC P0560 or P0620, perform appropriate test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS .