DTC C1254: Abnormal Shutdown Detected
- Perform diagnostic system check. See DIAGNOSTIC SYSTEM CHECK under DIAGNOSIS & TESTING. After performing diagnostic system check, go to next step.
- Turn ignition off. Disconnect EBCM harness connector. Install Universal Breakout Box (J-39700) using Cable Adapter (J-39700-99) to EBCM harness connector only. Check EBCM ground circuit for open or high resistance. Repair as necessary. After repairs, go to step 8. If circuit is okay, go to next step.
- Verify if battery has been disconnected recently. If battery has been disconnected, go to step 8. If battery has not been disconnected, go to next step.
- Check charging system. See STARTING & CHARGING SYSTEMS article in ACCESSORIES & EQUIPMENT. Repair as necessary. After repairs, go to step 8. If charging system is okay, go to next step.
- Check for poor connections at EBCM harness connector. Repair as necessary. After repairs, go to step 8. If connections are okay, go to next step.
- Using scan tool, clear DTCs, then perform automated test. Recheck DTCs. If DTC resets, go to next step. If DTC does not reset, problem is intermittent. See INTERMITTENTS & POOR CONNECTIONS under DIAGNOSIS & TESTING.
- Replace EBCM. After replacing EBCM, go to next step.
- Using scan tool, clear DTCs. Using scan tool, perform automated test. Recheck DTCs. If DTC resets, go to step 2. If DTC does not reset, system is okay.