Removal & Installation

CAUTION: Use correct fastener in correct location. Replacement fasteners must be correct part number for application. Fasteners requiring replacement or fasteners requiring use of thread locking compound or sealant are identified in service procedures. DO NOT use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage fastener. Use correct tightening sequence and specifications when installing fasteners in order to avoid damage to part and systems.

Remove the left side instrument panel (IP) insulator. Remove the steering column filler panel. Grasp turn signal/hazard flasher module and slide module to right to release module tabs from slots on body control module bracket. Disconnect harness connector. Turn and remove module. To install, reverse removal procedure.