Removal Procedure
- Remove the instrument panel trim pad. Refer to Instrument Panel Trim Pad Replacement
- Remove the passenger side SIR inflator module. Refer to REMOVAL (PASSENGER-SIDE)
for Airbag Instrument Panel Module Replacement in SIR
- Remove the brake pedal reinforcement nuts.
- Remove the air distribution ducts from the cross vehicle beam.
Courtesy of GENERAL MOTORS COMPANY
- Remove the bolts from the relay bracket and position the relay bracket aside
Courtesy of GENERAL MOTORS COMPANY
- Remove the bolts from the BCM bracket and position the BCM bracket aside
- Release the instrument panel wiring harness retaining clips and position the instrument panel wiring harness aside.
Courtesy of GENERAL MOTORS COMPANY
- Remove the bolts from the HVAC center module support bracket
- Remove the HVAC module center support bracket
Courtesy of GENERAL MOTORS COMPANY
- Remove the bolts from the HVAC module upper support brackets
Courtesy of GENERAL MOTORS COMPANY
- Remove the LH cross vehicle beam to hinge pillar bolts
Courtesy of GENERAL MOTORS COMPANY
- Remove the RH cross vehicle beam to hinge pillar bolts
Courtesy of GENERAL MOTORS COMPANY
- Remove the cross vehicle beam from the vehicle
- Remove the defrost distribution ducts from the cross vehicle beam.