Installation Procedure

Connect the ash tray harness electrical connector to the I/P harness.
Align the accessory trim plate to the I/P.
Install the tabs into the I/P openings.
Rotate the I/P accessory trim plate forward and press the clips into the retainers until fully seated.
NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Install the screws to the I/P accessory trim plate. Tighten the screws to 2 N.m (18 lb in).

Fig 1: Identifying I/P Accessory Trim Plate Bottom Screws
Courtesy of GENERAL MOTORS CORP.
Install the steering column filler. Refer to Steering Column Opening Filler Replacement .
Install the left I/P insulator. Refer to Instrument Panel Insulator Replacement (LH) .