LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 1999 >> Regal LS >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel - Analog >> Symptom Tests >> Automatic Transmission Control Position Indicator Illumination Malfunctioning

Automatic Transmission Control Position Indicator Illumination Malfunctioning

  1. If instrument cluster diagnostic system check was performed, go to next step. If instrument cluster diagnostic system check was not performed, go to INSTRUMENT CLUSTER DIAGNOSTIC SYSTEM CHECK  under SYSTEM TESTS.
  2. Connect scan tool. Using scan tool, check for instrument cluster DTCs. If no DTCs exist, go to next step. If any DTCs exist, go to SELF-DIAGNOSTIC SYSTEM  .
  3. Turn ignition switch to RUN position. Using scan tool, command automatic transmission control position indicator to turn on. If indicator illuminates, go to next step. If indicator does not illuminate, go to step  5 .
  4. Ensure ignition switch is in RUN position. Using scan tool, command automatic transmission control position indicator to turn off. If indicator illuminates, go to next step. If indicator does not illuminate, locate and repair problem in automatic transmission system. See appropriate TRANSMISSION SERVICE & REPAIR article.
  5. Replace instrument cluster. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION. Recheck system operation.
scientia non olet · About LEMON Manuals