Hub & Bearing Assembly: Removal
WARNING: This page is about a different car, the 1996 Pontiac Grand Prix, 1996 Oldsmobile Cutlass Supreme, 1996 Chevrolet Monte Carlo, 1996 Chevrolet Lumina, and 1996 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
- With vehicle on floor, remove hub cap and loosen axle shaft nut one turn. Raise and support vehicle. Remove wheel. Remove brake caliper, and wire aside. Remove caliper bracket and rotor.
- Remove axle shaft nut and washer. Use Front Hub Spindle Remover (J-28733-A) to force axle away from hub. Turn screw on remover until axle splines are just loose. Remove ABS sensor. Remove hub and bearing assembly.