Hub & Bearing Assembly: Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1996 Pontiac Bonneville, 1996 Oldsmobile Ninety-Eight, 1996 Oldsmobile LSS, 1996 Oldsmobile Eighty-Eight, and 1996 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
To install, reverse removal procedure. See Figure . Apply a light coat of grease to knuckle bore. Remove protective plastic cover (if equipped) and install hub and bearing assembly. Place transaxle in Neutral. Install and tighten hub and bearing assembly bolts to specification. See TORQUE SPECIFICATIONS .