RWD ("V" Body)
WARNING: This page does not describe the selected car, but rather 38 other vehicles, including the 1996 Saturn SW2, 1996 Saturn SW1, 1996 Saturn SL2, 1996 Saturn SL1, and 1996 Saturn SL. However, it is still accessible from the selected car via links, so may be relevant.
- Apply parking brake. Place gear selector to Neutral. Raise and support vehicle. Remove cover from selector lever position switch. Remove selector lever from switch. Disconnect harness connector from switch.
- Connect ohmmeter between switch terminals "E" and "H". Loosen selector switch-to-transmission bolts. Rotate switch slightly in both directions to determine range of electrical contact (about 5 degrees).
- Position switch in middle of contact range. Tighten hold-down bolts to 106 INCH lbs. (12 N.m). Install linkages and wiring harness. Tighten selector lever shaft nut to 71 INCH lbs. (71 N.m).