LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 1997 >> Park Avenue Ultra >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical - 3.8L V6 - VINS [K,1] >> Removal & Installation >> Oil Pan >> Removal & Installation (Except "F" Body)

Removal & Installation (Except "F" Body)

  1. Disconnect negative battery cable. Remove engine torque strut. Raise and support vehicle. Drain crankcase. Disconnect oil level sensor electrical connector. Remove oil level sensor and oil filter. Disconnect front exhaust pipe from manifold. Remove right front wheel and splash shield.
  2. Disconnect oil cooler pipes. Disconnect A/C compressor electrical connector. Remove A/C compressor and position aside. Disconnect engine mounts from frame.
  3. Remove flexplate access cover. Use transmission jack at transaxle to raise engine. Remove oil pan bolts and oil pan. To install, reverse removal procedure. Install oil level sensor after oil pan is installed. Tighten bolts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals